TP型铝电解电容器，是单向导针引出型式耐高温(105℃ 8000H)产品，性能稳定可靠适用于开关电源、高端适配器、LED电源、程控交换机、电子整流器以及耐高温等电子线路。

参考标准APPLICABLE SPECIFICATION

本承认书参考JIS-C-5101-1 和JIS-C-5101-4 制定。

This approval sheetconsulted the institute of JIS-C-5101-1 and JIS-C-5101-4.

 测试环境CONDITION OF TEST

如果没有其他规定，标准的测试、检验环境条件如下所示：

环境温度：15℃~35℃

相对湿度：45%~75%

大气压力：86kpa~106kpa

如果对测试结果有异议，可以在以下条件测试：

环境温度：20±1℃

相对湿度：60%~67%

大气压力：86kpa~106kpa

Unless otherwise
specified, the standard range of atmospheric conditions for making measurements
and tests are as follows

Ambient temperature：15℃to 35℃

Relative humidity    ：45% to 75%

Air pressure        ：86kpa to 106kpa

If there may be doubt on
the results, measurements shall be made within the following limits

Ambient temperature：20±1℃

Relative humidity     :60%
to 67%

Air pressure        ：86kpa to 106kpa

存放環境StorageEnvironment

環境溫?: 5℃ ~ 35℃, 環境相對濕?: 75%以下 .

Store the 
capacitor at a 
temperature of 5℃to 35℃and at 
a relative humidity of 
less than 75% .

存放環境?應有陽光直射,?宜高溫.

Store the 
capacitor in low 
temperature places free 
from direct sun 
shine .

存放環境?能有鹽分?油含?高的霧气.

Store the 
capacitor in places 
free from oil 
vapor?salt water 
vapor.

存放在遠?氯气?氨气??化氫?亞?酸?硝酸等有害氣體含?高的地方.

Store the 
capacitor in places 
far from toxic 
gases ( chlorine?ammonium?hydrogen sulfide?sulphurous acid?nitric acid , 
etc ) .

儲存環境?能有臭氧?紫外線或幅射.

Store the 
capacitor in place 
free from Ozone?ultraviolet ray or 
radiation .

符合 RoHSRoHScompliance

符合欧盟RoHS的新标准，若客户有特殊要求，按照双方签订的相关协议为准。

Accord with the latest standard of 
RoHS,if customers have any special requirements,according to the
relevant agreements which signed by both parts.

使用须知Instructions

直流铝电解电容只能使用在直流电路上,其极性必须标明.

DC aluminum electrolytic capacitors can only be
used in DC on the road, its polarity must be marked.

在电路回路中如不清楚或不明确线路的极性时,则建议使用无极性铝电解电容.

In the circuit loop, such as clear or not clear
when the polarity of the line, it is recommended to use non-polarized
electrolytic capacitors.

铝电解电容器的工作环境温度不能超过规定的使用温度范围.

Electrolytic capacitors is the operating
temperature can not exceed the specified temperature range.

铝电解电容器应该储存于低温及干燥场所,如储存期较长,则使用前应用额定电压对其重新老练.

Electrolytic capacitors should be stored in low
temperature and dry place, such as the storage period is longer, the rated
voltage is applied before using them to re-experienced.

通过铝电解电容器的纹波电流不应超过其允许范围，如果超过了规定值，需选用耐大纹波的铝电解电容器.

The ripple current through the electrolytic
capacitor should not exceed the allowable range, if more than the specified
value, the need to use a large ripple-resistant aluminum electrolytic
capacitors.

使用时铝电解电容器的工作电压不应超过其额定工作电压.

Use the operating voltage aluminum electrolytic
capacitors should not exceed its rated voltage.

电烙铁等高温发热装置应与铝电解电容器之塑料外壳保持适当的距离,以防止过热造成塑料管破裂.

Electric iron and other high-temperature heating
with aluminum electrolytic capacitors of the device should maintain an
appropriate distance from the plastic housing to prevent overheating caused by
plastic pipe rupture.

在焊接铝电解电容器时,其焊接时间及焊接温度不应超过10秒钟及260摄氏度.

In welding aluminum electrolytic capacitor, the welding time
and weld temperature should not exceed 10 seconds and 260 degrees Celsius.

对引线、端子,如施加超过规定的力,将会破坏铝电解电容器的内部结构.

Of lead, terminal, such as applied exceeds the force will destroy the
internal structure of aluminum electrolytic capacitors.