参数                  设定范围                        参数定义                                                                             出厂设定

AL1                 0--100?                   上偏差报警（AL1）设定值                                                       ３
AL2               ０±１℃                 风机状态转换偏差                                                                      -１
SC                ±２０℃                 显示值误差修正修改里外误差                                                 -  -            
ATU              0-1                            自整定命令（0：OFF，1：ON）                                             ０
P                    ０～１００?         比例带，Ｐ越大，系统增益越低，                                         ３
                                                             稳定性好．Ｐ越小可提高系统，消除静差．
I                   ０～４３２０秒    积分时间，Ｉ越大积分越弱，可减小＂过冲＂现象．     1000
d                 ０～１２００秒    微分时间，一般取1/4Ｉ　                                                         250
T                    ０～６０                 周期，采用可控硅做为功率输出,天龙八部私服发布站，一般取2~3秒                  3
LCy                0～２                      锁定(0:OFF,巴菲特定律解读,1:全锁定，2:除ＳＰ外都锁定．                            2


在开机正常状态下,制鞋行业ERP管理系统前后相关工作，按住ＳＥＴ键8秒钟,赶快转载吧！！“60条令你大吃一惊的小常识”让你的生活更完美！！，进入C菜单．
C:菜单
HL       1.0左右        斜率调整                                      --
0UT     ０～１０0       功率输出                                      45

价钱只供参考，详情价格：请与我联系！