Model

TDS1202S

TDS1122S

TDS1062S

Oscilloscope mode

Bandwidth

200MHz

120MHz

60MHz

Real-time Sample Rate

1GSa/s

Equivalent Sample Rate

25GSa/s

SEC/DIV Range

2nS/div-2000S/div (in a 2, 4, 8 sequence)

Delay Time Accuracy

500ps

Vertical

A/D Converter

8-bit resolution

VOLTS/DIV Range

2mV/div～5V/div at input BNC

Position Range

±50V(5V/div),±40V(2V/div～500mV/div), ±2V(200mV/div～50mV/div)±400mV(20mV/div～2mV/div)

Record Length

Single-channel: Maximum 2M; Dual-channel:Maximum 1M

Trigger

Trigger Sensitivity
(Edge Trigger Type)

DC: CH1/CH2(Typical) 1div from DC to 10MHz;1.5div from 10MHz to Full

AC: Attenuates signals below 10Hz

HF Reject: Attenuates signals above 80kHz

LF Reject: Attenuates signals below 150kHz

Noise Reject: Reduces trigger sensitivity

Trigger Level Range

CH1,CH2: ±8 divisions from center of screen

Trigger Level Accuracy,
typical (Accuracy is for signals having rise and fall times ≥20ns)

CH1,CH2: ±(0.3div×V/div) (within ±4 divisions from center of screen)

Holdoff Range

100ns-10s

Trigger Type

Edge

Trigger on the rising or falling edge

Pulse Width

Trigger (when >,<,=,≠) on positive or negative pulses
Pulse Width Range: 20ns-10s

Video

Trigger on an NTSC, PAL, or SECAM standard video signal
Line Range: 1-525 (NTSC), 1-625 (PAL/SECAM)

Slope

Trigger (when >,<,=,≠) on a positive or negative slope
Set Time: 20ns–10s

Overtime

from the rising or falling edge
Set Time: 20ns-10s

Alternate

Internal trigger on edge, pulse width, video or slope

Measurement

Cursors

Manual: The difference between voltage cursors △V; the difference between time cursors △T; 1/△T calculated by Hz.
Tracing: The voltage and time at a waveform point

Automatic

Pk-Pk, Max, Min, Mean, Cyc RMS, Frequency, Period, Rise Time, Fall Time, Positive Width, Negative Width

Meter Mode

Max.Resolution

6,000 Counts

DMM Testing Modes

Voltage, Current, Resistance, Capacitance,Diode & Continuity

Max. Input Voltage

AC: 600V, DC: 800V

Max. Input Current

AC: 10A, DC: 10A

Input Impedance

10 MΩ

Isolation