CBF-300防爆轴流风机，CBF-400防爆轴流风机，CBF-500防爆轴流风机，CBF-600防爆轴流风机
巨祥防爆公司网站https://www.jxfb.cn/商铺网站https://www.jexfb.com/ 电话    手机：.,

详细介绍：

　　FAG系列防爆壁式排风扇（IIB）
1、适用于爆炸性气体环境1区、2区；
2、适用于IIA、IIB级爆炸性气体环境；
3、适用于温度组别为T1-T4的环境；
4、适用于石油采炼、储存、化工、医药、及军事设施等爆炸性危险环境；
5、作为厂房、仓库通风换气，实验室内空气的流通与更新之用。
产品特点
1、防爆壁式排风扇由防爆电机、扇叶、面板等部分组成；
2、防爆壁式排风扇面板采用优质钢板焊接成型，叶片由铝合金压铸成型，表面高压静电喷塑；
3、外形美观、采用一体式安装，安全可靠；
4、带有减振装置，运行噪音低；
5、钢管或电缆布线。
执行标准：GB3836.1、GB3836.2、IEC60079
防爆标志：ExdⅡBT4
额定电压：AC 220/380V
额定功率：0.18 KW       0.37KW       0.55KW        0.75KW
扇叶直径：300mm        400mm        500mm         600mm
风量：    2280m2/h      2880M2/h      5700M2/h      8700M2/h
主轴转速：1450 r/min     
防腐等级：WF1
引入口规格：G3/4"
适用电缆外径：φ9mm~φ14mm
首先检查框架、风叶有无变形，扇叶转动是否灵活，有无摩擦现象。检查所有紧固件是否齐全、拧紧、应有防爆合格证编号。
线路电压必须与电机上额定电压相符。
用500V兆欧表检查电动机的绝缘电阻，其电阻值若小于5MΩ,则应用用烘干法或短路电流法进行干燥处理，使其绝缘电阻大于5 MΩ。
必须配用小型防爆开关作电源开关，或将普通开关安装于室外无爆炸性危险的地方。
接电源的电缆外径应与密封圈相符，拧紧、压紧螺母后应保证密封圈与电缆间、密封圈与出现咀间无间隙，否则将失去隔爆性能。
装配时应保证防爆间隙小于0.2mm，更换电机轴承的润滑脂，其润滑脂牌号为ZG-2H复合钙基润。
防爆电动机非接线部分不可随意拆卸，接线时，打开接线室的盖，穿入引线接到端子上，接好后，盖上盖拧紧螺钉使其隔爆面间隙小于0.2mm，再上紧出线器，使引线不能窜动。
使用中的排风扇应经常清扫电机上粉尘及其它积聚物，以免影响散热。
长期不用的排风扇重新使用时，应按说明书再检查一遍，合适后方可使用

First check the frame, whether the fan blade deformation, the fan blade rotation is flexible, with or without friction phenomenon. Check all fasteners are complete, tighten, should be proof certificate No..
The line voltage must be consistent with the rated voltage of the motor.
With 500V megger check the motor insulation resistance, the resistance value less than 5MΩ, applied drying drying method or the short-circuit current, its insulation resistance greater than 5 MΩ.
Must be equipped with a small explosion-proof switch for the power switch, or will be the ordinary switch installed in the outdoor explosive.
The power supply cable diameter should correspond with the seals, tighten the compression nut between the seal and the cable should ensure no gap between the seals and appear Tsui, otherwise will lose flameproof performance.
Assembly should ensure the safety gap, less than 0.2mm, replace the motor bearings, grease, grease grades a ZG-2H composite calcium-based Run.
Non-wiring part of the explosion-proof motor can not disassemble, wiring, open wiring compartment cover, penetration leads to terminals connected, cover and tighten the screws to make it flameproof surface gap is less than 0.2mm to a tight qualifying , the lead can not traverse.
The exhaust fan should always use cleaning dust and other buildup in the motor, so as not to affect the heat dissipation.
Shall be specified when the exhaust fan is not being used for a long period of re-use, and then check it again, suitable before use

CBF-300防爆轴流风机，CBF-400防爆轴流风机，CBF-500防爆轴流风机，CBF-600防爆轴流风机
巨祥防爆公司网站https://www.jxfb.cn/商铺网站https://www.jexfb.com/ 电话    手机：.,