Parameter conditionsUnless otherwise specified, all voltages are referenced to VSS.6.1.1Minimum and maximum valuesUnless otherwise specified, the minimum and maximum values are guaranteed in the worstconditions of ambient temperature, supply voltage and frequencies by tests in produion on100% of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given bythe seleed temperature range).Data based on charaerization results, design simulation and/or technology charaeristicsare indicated in the table footnotes and are not tested in produion. Based oncharaerization, the minimum and maximum values refer to sample tests and represent themean value plus or minus three times the standard deviation (mean ±3σ).6.1.2Tical valuesUnless otherwise specified, tical data are based on TA = 25 °C, VDD = VDDA = 3.3 V. Theyare given only as design guidelines and are not tested.Tical ADC accuracy values are determined by charaerization of a batch of samples froma standard diffusion lot over the full temperature range, where 95% of the devices have anerror less than or equal to the value indicated (mean ±2σ).6.1.3Tical curvesUnless otherwise specified, all tical curves are given only as design guidelines and arenot tested.6.1.4Loading capacitorThe loading conditions used for pin parameter measurement are shown in Figure 10.6.1.5Pin input voltageThe input voltage measurement on a pin of the device is described in Figure 11