一．电器性能规格　ＥLECTRICAL  CHARACTERISTICS

测试条件   Test  Conditions

在微小电流(100mA )以下测试

Measured  at  small l current (100mA or less)  1000HZ

输入500V电压1分钟,按以下方式测试:Apply a voltage of 250V DC for 1 min to following portions  after mhich measurement shall be made:

(1)    塑胶体与针脚之间  (1)Between  body  and  conductor

(2)    不接触的针脚之间  (2)Between  conductor  not  to  be contact

输入AC500V(50-60HZ)电压,1分钟感应电流为0.5MA,按以下方法测试:

AC 250V ims(50-60HZ) for 1 min trip current: 0.5 mA

(1)塑胶体与排脚之间  (1)Between  terminals

(2)不接触的排脚之间:  (2)Between  individual terminals and frame

-25℃----+75℃

在没有指定的情况下测试温度,湿度,气压如下:

Unless otherwise specified , the stardard range or atmospheric conditions  for making measurements and tests are as follows

(1)    温度为5℃--35℃       (1)Ambient temperature:5℃to  35℃

(2)    湿度为45%--85%       (2)Relative humidity :45% to 85%

(3)    气压为80KPA----106KPA (3)Air pressure : 80Kpa  to  106Kpa

二.机械性能规格  MECHANICAL  CHARACTERISTICS

在排脚前端任意一个方向的先端加上300克力力度测试，时间为15秒

A static load of 300gf shall be applied to the tip of the terminal for 15 sec in any direction

负荷：在负荷的条件下以每分钟25-30回的频率进行100,000次的负荷测试;

Aswitch shall be subjected to 100.000 cycles at a speed of 25-30 cycles for 1 min