厂家自主生产销售各种型号的电池测试仪，详细请电话联系，

H—2016智能电池容量测试仪使用说明书

一、本仪器采用微电脑技术、PID自动控制、恒流放电，放电电流为0．5~10A可调（恒流），放电时间自动记录、保存，电流、总电压、单只电压﹑时间显示，能测定电池的容量。可检测标称12V，24V，36V，48V,72V的电池组。终止电压：10.5V，21V，31.5V，42V，63V,自动判别电池组电压。是铅酸电池生产，检测，维修以及售后处理的必备工具。                                     

二、相关标准：

1，根据国标在25℃环境温度下，以两小时率来测试电池容量，即7AH的电池以7/2=3.5A的电流放电，10AH电池的电池以10/2=5A的电流放电，依次类推。一般的新电池能达到120分钟以上的放电时间。

2，电池容量计算公式：{放电时间T（分）÷60×放电电流I（A）}AH。

三：操作步骤：

1，插好并拧紧正极夹头、负极夹头和采样线夹头.

      2，插上电源（AC220V），”嘀”一声电源指示灯亮。

      3，按“设定”键，默认值为10A，按“▲▼”键调节所需要的电流。（0.5-10A）

4,电池组串联好,电池之间用1.5平方以上的电线连接,电线要求尽量短;串联好的电池的编号由负极到正极依次为①号②号③号④号.

5,分电压夹头连接方法;1号电池正极,2号电池正极,3号电池正极,各接一根,(采样黄线)不分序号,自动设别.

6，按“放/停”键即开始放电，放电结束，保存放电时间,显示每只电池电压。

7,当放电过程中按一下“设定”键,显示当前各单电压及总电压,再按返回原来状态.

8,仪器放电过程中不能设定电流值,只能在放电之前先设定好电流值放电.

9,本仪器带充电接口,放电完成自动充电,充电器自配.

四、随机配件:

1~正极线夹1根.

2~负极线夹1根.

3~采样线夹1根.

4~电源线1根.

5~说明书1份.

五﹑主要参数:

           1,电源～220V     50∕60HZ

           2,放电电池组:12V、24V、36V、48V、72V

           3,放电电流:0.5A～10A可调

           4,放电电流:2‰

           5,外观尺寸:20㎝×15㎝×28㎝.

           6,重量:5㎏

六、注意事项：

1，保持通风，风扇不转时应及时维修。

2，若按“设定”键无反应时，请关掉电源，重新开始。

3，如按“放/停”键没有反应时，请检查极性有没接反，或电池组一点电量也没有.

电话：0572—

传真:

长兴海海电子有限公司

地址：浙江省长兴县光明路288号

网址:WWW.CXHHDZ.CN

H - 2016intelligent battery capacity tester instructions

A, this instrument adopts microcomputer technology, PID automatic control, constant exile electricity, discharge current for 0.5 ~ 10A adjustable (constant-current), discharge time automatic recording, preservation, current, total voltage, single only voltage, time to show, can accurate determination of your battery capacity. Can detect the nominal 12V, 24V 36V, volt, 72V, the battery pack. Termination voltage: 10.5 V, 21V, 31.5 V, 42V, 63V, automatic discriminant battery voltage. Is lead-acid battery production, testing and maintenance and after-sales processing of necessary tools.

Second, the related standard:

1, according to gb in 25℃environmental temperature in 2 hours, rate to test battery capacity, namely 7AH battery to 7/2 = 3.5 A discharge current, 10AH batteries battery to 10/2 = 5A of discharge current, ordinal analogy. General new battery can reach more than 120 minutes of discharge time.

2, battery capacity calculation formula: {discharge time T (points) voting 60 x discharge current I (A)} AH.

Three: operation steps:

1, insert and screw down the positive chuck and anode chuck and sample line chuck.

2, plug (AC220V), "di" 1 power indicator.

3, press "set" button, the default value of 10, press "▲▼" button to adjust needed current. (0.5-10A)

4, battery, the battery is used between series more than 1.5 square wire connection, wire requirements as far as possible short, Tandem good battery anode to positive in turn by the Numbers as (1), (2), (3), (4) number.

5, divide voltage chuck connection method, 1 the battery anode, 2 battery anode 3 battery anode, each connect a root, (sampling yellow line) regardless of serial number, automatic set don't.

6, press "put/stop" button, it will begin to discharge end of discharging, save discharge time, showing every only battery voltage.

7 and when discharging process click "setup" button to display the current each single voltage and total voltage, and press return to its original shape.

8, instrument discharge process cannot set current only at discharge before setting good result discharge.

9. The instrument with charging interface, complete discharge automatically charges, charger the mixed.

Four, random accessories:

1 ~ positive wire clip 1 root.

2 ~ anode wire clip 1 root.

3 ~ sampling wire clip 1 root.

4 ~ the power cord 1 root.

5 ~ 1 portion of the specification.

Five, main parameters:

1, power ~ 50/220V 60HZ

2, discharge battery pack: 12V, 24V, 36V, volt, 72V

3, discharge current: 0.5 A ~ 10A adjustable

4, discharge current accuracy: 2)

5 appearance, size: 20㎝by 15㎝x 28㎝.

6, weight 5㎏

Six, note:

1, keep ventilated, fan doesn't turn should be timely maintenance.

2, if press the "set" button no response, please switch off the power supply and start again.

3, if press "put/stop" button no response, please check the polarity have didn't answer against, or a little power battery could not.

Telephone: 0572-

Fax:

Chang xing hai hai  electronic Co., LTD

Address: zhejiang ChangXingXian guangming road 288 number

Url: WWW.CXHHDZ.CN