-
图文详情
-
产品属性
-
相关推荐
类型 | 数字式电压测量仪表 | 品牌 | 美星电器 |
型号 | MX-164测电笔 | 测量范围 | 12-220(V) |
输入电压 | 12-220(V) | 输出电压 | 220(V) |
环境温度 | !!!(℃) | 重量 | !!!(g) |
外形尺寸 | !!!(mm) | 电压测量误差 | 0 |
若需提供样品,我部将收取样品费,样品费统一价:50元,若贵方日后和我部合作成功,我们将退还收取的样品费,谢谢合作!
使用说明
本测电笔适用于直接测检12-220V的变直流电和间接测检交流电的零钱,相线和断点检测。
1电压测检:
a.后数字为所测电压值;
b.未到高段显示值70%时,显式低段值;
c.测量直流电时应手碰负极;
d.测量少于12伏电压物体是否带电,可用感应电极;
e.带感应电的被测物必须接地或接零。
2感应测检:
检测并排线路时应增大线间距或用手按住被测物
3断点测检:
沿相线纵向移动,显示窗内无显示是为断点处。
注意事项:
勿同时接住两个电极进行测试。否则检测结果将会不准确或会削弱感应灵敏度。
Dirctions:
This tester is suitable to meas. ure 12-220V A.C. and D.C. diectly as well as measure the groud line,phase line and the breakpoint of the A.C. in directly
1.Voltage measeurement:
(1)the final digits are the meaasured voltage.
(2)if the display value can not reach 70% of the high section, it will display the lower section.
(3)touch the negative pole with hand when megsure D.C. circuit.
(4)use induction pole when me asured bodies under 12 volts charged or not.
(5)when induction body is under measured, it must connect to ground or zerc.
2.Induction measurement:
when measurements is performed on one of the panallet lines, it is necessary to widen them, or press the measured line with your hand so as to eliminate interference.
3.Breakpoint detection.
move longitudinally along the live wire, display window with nothing means the breakpoint.
Caution:
Do not press two poles at the same time while detecting, or it won't display the exact section or the induction will be decreased.
地址:浙江义乌国际商贸城2期F2-13620
联系人:张伟斌
TEL/FAX:
手机:
Email:
地址:浙江义乌国际商贸城2期F2-13620
联系人:张伟斌
TEL/FAX:
手机:
Email:
地址:浙江义乌国际商贸城2期F2-13620
联系人:张伟斌
TEL/FAX:
手机:
Email:
地址:浙江义乌国际商贸城2期F2-13620
联系人:张伟斌
TEL/FAX:
手机:
Email:
地址:浙江义乌国际商贸城2期F2-13620
联系人:张伟斌
TEL/FAX:
手机:
Email: