产品详情大图
OS-3040D模拟存储示波器
价格：电议
地区：浙江省 杭州市
电 话：0571-88009259
手 机：15988108750
传 真：86-0571-88009576

杭州力禾电子仪器有限公司

免费会员 营业执照未上传

>
全部产品 进入商铺

特性介绍

● 数字和模拟示波器组合的性能

● 2通道同步取样的速率为20MS/s

● 信号重复等效值60MHz

● 每个通道存储量达2K字节

● 实时切换和存储模式

● 双存储记忆体模式

● 机板预先触发，使得波形线性比例观察点生效

● 卷模态提供连续观察慢性波形

● 平均功能提供总和平均达到256倍

● 线性和正弦窜改功能适合正弦或脉膊曲线信号

● 放大功能可详细观察波型

● 读数功能可将所测量的电压时间频率显示在屏幕上

● 用HP-GL指令和RS232界面卡现存可直接拷贝现存屏幕显示

规格

　 OS-3020D OS-3040D OS-3060D
CRT阴极管 配置和有效视频 6 inch rectangular screen with internal graticule: 8x10DIV (1div=1cm), marking for measurement of rise time. 2mm subdivisions along the central axis.
加速电势 +1.9kV approx +11.5kV approx +11.5kV approx
荧光器 P31 (Standard)
聚焦 Possible (with auto - focus correction circuit)
旋转线迹 provided
比例照明 Variable
亮度控制 provided
高强度Z轴输入 输入信号 Positive going signal decreases intensity + 5Vp-p or more signal cases noticeable modulation at normal intensity settings
频宽 DC to 2MHz (-3dB)
触发耦合 DC
输入阻抗 20kOhm - 30kOhm typical
输入电压 30V (DC + peak AC)
垂直偏转 频宽 (DC Coupled) 
DC to 20MHz normal 
DC to 7MHz magnified		 DC to 40MHz normal 
DC to 7MHz magnified		 DC to 60MHz normal 
DC to 10MHz magnified
模式 CH1,CH2,DUAL,ADD (CHOP: Time/div switch -0.2s to 5ms, ALT: time/div. switch -2ms to 0.2us) CH1,CH2,DUAL,ADD (CHOP: Time/div switch -0.2s to 5ms, ALT: time/div. switch 2ms to 0.1us)
偏转系数 5mV/div to 5V/div in 10 calibrated steps of a 1-2-5 sequence.
Continuously variable between steps at least 1:2:5
(x5 MAG : 1mV/div to 1V/div 10 calibrated steps)
准确度 Normal: +/-3%, magnified: +/-5%
输入阻抗 Approx, 1Mohm in parelle1 with 25pF+/-3pF
输入电压 Direct 250V (DC + AC Peak) (with probe: refer to probe specification)
输入耦合 DC- GND - AC
延升时间 17.5ns or less (50ns or less: x5) 8.8ns or less (50ns or less: x5) 5.8ns or less (35ns or less: x5)
通道1 输出 20mV/div into 50ohm : DC to 10MHz (-3dB)
极性逆向 CH2 only
信号延时 Delay cable supplied for OS-3040D / OS-3060D
水平偏转 显示方式 A, A int B, B, TRIGD, X-Y
A 时基 0.2us/div to 0.2s/div in 19 calibrated steps 1-2-5 sequence, uncalibrated continuous control between steps at least 1:2:5 0.1us/div to 0.2s/div in 20 calibrated steps 1-2-5 sequence, uncalibrated continuous control between steps at least 1:2:5
锁定时间 Variable with the holdoff control
B 时基 0.2us/div to 20us/div in 7 calibrated steps 1-2-5 sequence 0.1us/div to 0.2us/div in 20 calibrated steps 1-2-5 sequence
延时扫描 1 div or less to 10 div or more
延迟抖动 better than 1:20000
扫描放大 10 times (maximum sweep rate : 20ns/div) Note: 50ns/div, 20ns/div of A TIME BASE are uncalibrated 10 times (maximum sweep rate : 10ns/div)
准确度 +/-3%, additional error for magnifier +/-2%
触发系统 触发模式 AUTO, NORM, TV-V, TV-H
触发源 CH1,CH2,LINE,EXT
耦合 AC
倾斜率 + OR -
TV-V, TV-H At least div or 1.0Vp-p Composite Sync.
外部触发输入阻抗 1Mohm
输入电压 250V (DC + Peak AC)
灵敏度和频率/自动和标准
　 20Hz-2MHz 2MHz-20MHz
INT 0.5div 1.5div
EXT 0.2Vp-p 0.8Vp-p
　 20Hz-2MHz 2MHz-20MHz
INT 0.5div 1.5div
EXT 0.2Vp-p 0.8Vp-p
　 20Hz-2MHz 2MHz-20MHz
INT 0.5div 1.5div
EXT 0.15Vp-p 0.3Vp-p
X-Y轴操作 X 轴 (Same CH1 except for the following) Deflection factor; same as that of CH1/Accuracy : +/-5%/Frequency response: DC to 500kHz (-3dB)
Y 轴 Same as CH2
X-Y 轴相位相差 3o or less (at DC to 50MHz)
直读功能 游标读数功能 Voltage reference △V: △-REF, Frequency reference 1/△T: △-REF
面板设置显示 Verical axis CH1,CH2: V/div, UNCAL,MAG (converted value)
Note: displayed when the vertical mode is CH1,CH2,DUAL,ADD not displayed when the B node
Horizontal axis: S/DIV,UNCAL,MAG (converted value)
Effective Cursor Range from Center Graticule Vertical: within +/-3div, Horizontal: within +/-4div
解析度 1/25 div
数字储存功能 显示记忆体和储存记忆体 1000 Words/CH,1000 Words/CH x 2
Acquisition Memory 5us/div-20s/div: 2000 words/CH
0.2/div-20us/div: 1000 words/CH		 5us/div-20s/div: 2000 words/CH
0.1/div-2us/div: 1000 words/CH
垂直解析度 25 point/div
水平解析度 100 point/div
取样速率 20MS/s
数字频宽/单状态效应 5MHz
Repetitive Event 20MHz 40MHz 60MHz
Data Acquisition Method

NORM mode: storage the data each time trigger
AVG mode: averaging from 4 to 256 times
ROLL mode: data is continuously stored on the CRT
HOLD mode: data is held for the NORM, AVG.ROLL
SINGLE: wave form is held after stored
AMAG mode: simultaneously displaying the original waveform and its nagnified waveform
G-NG mode: judgement and comparing of acquisition signal

储存数据 Up to two storage data can be saved.
Saved data can be recalled to the display whenever required.
Pre 触发 Variable (0.04 div step)
Plotter Plotter output of the CRT displayed information to an HP-GL.
Plotter via the RS-232C interface
数据输出 RS-232C
Magnified Display X 10 by Time/div switch or MAG switch
X-Y 轴操作

Single trace X-Y X axis=CH1 * X axis=SA, Y axis=CH2 * Y axis=SB
Dual trace X-Y X axis=CH1 * Y axis=CH2
Sensitivity X axis:CH11 mV-5V/div +/-5% Y axis=CH2 1mV=5V/div+/-5%
Phase error 3° or less from DC-50kHz

Sweep Time 0.2us/div-20s/div rejpetitive signal: 0.2us/div-2us/div
roll mode: 0.5s/div-20s/div ALT: 0.2us/div-0.5ms/div
CHOP: 1ms/div-20s/div		 0.1us/div-20s/div rejpetitive signal: 0.1us/div-2us/div
roll mode: 0.5s/div-20s/div ALT: 0.1us/div-0.5ms/div
CHOP: 1ms/div-20s/div
Readout Function (Panel setting display)
V/div, uncal, MAG, S/DIV, uncal, MAG
X-Y, Trigger point ,number of averaging , roll mode, smoothing, interpolation method,
save memory information, probe setting (cursor readout)
Voltage differnce △V: △-Ref, Time difference △T: △-Ref,
frequency 1/△T: △-Ref, Pre-trigger TRG: △
校准器 Probe Adjustmetn approx. 1kHz frequency, 0.5V(+/-3%) square wave duty ratio: 50%
电源供应 Voltage Range / Frequency 100,120,220,240, VAC +/-10%, 50/60Hz
功率 approx. 65W
物理参数 重量 approx. 8.5kg
体积 320)W)×140(H)×430(L)mm
环境参数 Temperature Range for Rated Operation +10℃ to +35℃ (+50℉ to 95℉)
Max. Ambient Operating Temperature 0℃ to +40℃ (+32℉ to 104℉)
Max. Storage Temperature -20℃ to +70℃ (-4℉ to 158℉)
Humidity Range for Rated Operation 45% to 85%RH
Max. Ambient Operating Humidity 35% to 85%RH